Hello,
Using the mE5 VQ8-CXP6D and one camera, I want to output the original image to one DMA and the binarized image to the other DMA. It does not work if it is designed as in the image below. Is there any other way?
thanks.
Hello,
Using the mE5 VQ8-CXP6D and one camera, I want to output the original image to one DMA and the binarized image to the other DMA. It does not work if it is designed as in the image below. Is there any other way?
thanks.
Hello,
The image simulation after the threshold does show a result.
What makes you think that it does not work?
Have you already changed the threshold, since you are working with 32 bit? It could be that a threshold of 255 does not bring the desired results.
To the best of my knowledge, however, this is how it should work.
Best regards
Matthias
Hello,
The simulation works fine. As in the attached image, VA files built after design do not work on microDisplay. So, we inquired how to output the image data acquired by one camera in the mE5 VQ8-CXP6D to two DMAs.
Thank you.
Hello,
After enabling the "Ignore cam clock state" item in "microDisplay-settings", the issue was resolved.
Thank you.
DMA3600 / 高达3.6 GB/s的PCIe数据带宽(PCIe x8 Gen2),two 8 Bit 32X is 4000MP/s + 4000MP/s, it's too high.