Dear All.
I would assign encoder signal to flash two lights and I want to simulate signal.
How to generate the positive and negative signals of the encoder AB phase on Visual Applets?
Thanks.
Dear All.
I would assign encoder signal to flash two lights and I want to simulate signal.
How to generate the positive and negative signals of the encoder AB phase on Visual Applets?
Thanks.
The attched VA design includes the design of the screenshot below.
It is based in signal operators that decode an AB encoder signal at Mode X2:
The ShaftEncoderCompensate makes sure that ony forward pulses are used.
The DownScale selects the correct phase (=2) for A or B switching Illumination 1 or 2, while the diagram below shows 3 phases.
Signal analysis is only possible in the runtime and can be done on the basis of our Scope Operator.
The Scope enables a very precise analysis.
Hi Björn,
Thank you so much for the help!
Jesse
Thank you for your positive feedback,